3
1473
8
2021
-
ESI
DECLARATION OF CONFORMITY
Sleipner Motor AS
P.O. Box 519, Arne Svendsensgt. 6-8
N-1612 Fredrikstad, Norway
Declare that this product with accompanying standard control systems complies with the
essential health and safety requirements according to:
DIRECTIVE 2013/53/EU
DIRECTIVE 2014/30/EU
DIRECTIVE 2014/35/EU
MC_0020
Contents
• Always keep the boat’s motor running when operating the windlass.
• Always turn off the power to the windlass when it is not operated.
• The anchor must always be secured with security line when windlass is not in use.
• While dropping anchor, do not push the “UP” button until the anchor is resting at the seabed.
• Windlass and accessories must be installed and used in a manner that will not cause damage or injury.
• Personnel qualifi ed for high current installations must carry out or check the installation.
• Do not mount any windlass parts in hazardous environments (I.e. flammable fumes or gasses).
• The control unit is NOT protected from water ingress, it must be installed in a dry area and not exposed for
water.
MC_0403
Considerations and Precautions
RESPONSIBILITY OF INSTALLER
The installer must read this document to ensure necessary familiarity with the product before installation.
Instructions in this document cannot be guaranteed to comply with all international and national regulations. It is the responsibility
of the installer to follow all applicable international and national regulations when installing Sleipner products.
The recommendations given in this document are guidelines ONLY, and Sleipner strongly recommends that advice is obtained from
a person familiar with the particular vessel and applicable regulations.
This document contains general installation instructions intended to support experienced installers. If you are not skilled in this
type of work, please contact a professional installer for assistance.
If required by local regulation, electrical work must be done by a licensed professional.
Health and safety procedures must be followed during installation.
Faulty installation of Sleipner products will render all warranties given by Sleipner Motor AS.
MC_0038
IMPORTANT NOTICE S-LINK™ SYSTEM
When installing an S-Link™ system DO NOT connect any other control equipment directly to the S-Link™ bus except original Sleipner S-Link™
products. Connecting third-party equipment must always be connected through a Sleipner-supplied interface product. Any attempt to directly
control or connect into the S-Link™ control system without a designated or approved interface will render all warranties and responsibilities
of all connected Sleipner products. If you are interfacing the S-Link™ bus by agreement with Sleipner through a designated Sleipner supplied
interface, you are required to install at least one original Sleipner control panel to enable efficient troubleshooting if necessary.
MC_0265