SLEEPTRACKER TEMPUR-Ergo Smart Base, Installation Manual, Page: 6 / 54

10 11
Locate and dispose of the QR code
sheet from the
secondary
base (the
base on your right as you’re standing at
the foot of the bed).
• The
secondary
base is the side
with the Sleeptracker processor
we’re disconnecting during this
installation. The QR code from this
side connects only to the
secondary
processor, which will not work after
the installation. Dispose of it now to
prevent confusion later.
Locate the QR code sheet from the
primary
base (the left base as you’re
standing at the foot of the bed). Set it
aside for later.
• The primary
base is the side with
the Sleeptracker processor that will
remain connected throughout the
installation.
• The customer will need this QR
code later in order to connect to the
correct Sleeptracker processor.
Set the bases up on their sides, with the
undersides facing each other.
STEP
4
STEP
5
STEP
6
Untie the black battery backup
module, then disconnect it from the
white Sleeptracker Smart Cable.
Plug the sync cable into the
Sleeptracker Smart Cable, in the port
where the battery backup module was
just removed.
Note:
there is a
sync cable in each
electronics bag. Only
one is used during the
installation.
If you run into difficulty, align the
notches on the cable and the port.
STEP
7
STEP
8
• In order for the Sleeptracker app to function, the controls of both
bases must be connected. The customer will regain individual control
of either side when they connect the Sleeptracker app.
• Pick either base to start with.
SYNC THE CONTROLS FOR THE TWO BASES TOGETHER
!