Appendix H:
Troubleshooting
If sleep results change for no apparent rea-
son, the first thing you should check is to
make sure the electromagnet is generating
a pulsed magnetic field.
To do this, boot device and once screen
shows MODE SLEEP 1, hit ENTER/
START button TWICE; you should now see
blue
diode blinking on controller. Now, refer
to the photo below.
Remember, you must have the EDGE of
the ring suspended 1/4 inch (1-2 cm) only
above the center of the core to be able to
feel the pulsing.
If no pulse is felt, unplug the magnet and
re-plug firmly. Check for pulse once again.
Make sure to spin the jack while inside the
plug if no pulse is felt and check again. Call
for service if instructions above do not yield
recognizable output.
Sometimes, based upon mental state at
time of bed, one may have to ratchet down
the frequency if sleep onset seems de-
layed. Usually, if you normally sleep in RE-
COVER or SLEEP MODES 1 or 2; reset
device for MODE SLEEP 3.
If
blue
diode on power supply is not lit
when fully plugged into outlet;
•
check outlet,wall switch or move power
supply to different outlet
•
if controller has power,
blue
diode may
have failed on power supply
•
if no power on controller power supply
may have failed, call for service
EARTHPULSE™ controller does not have
power
•
If diode is lit on power supply, unplug
power supply from EarthPulse™ and
then plug in again
•
hit ENTER/START button
•
if controller fails to receive power call for
service
EarthPulse™ LCD characters become jum-
bled, power off 5 sec. and power on again.
EarthPulse™ LCD characters are light or
missing, power off 5 sec. and power on
again.
Summary of Contents for EarthPulse v.4.7
Page 1: ......
