Skywell 5T1.5, User Manual, Page: 6 / 16

IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-SKY-WELL(759-9355) for assistance.
6
WATER FILTER BREAK-IN PRIOR TO USE (OPTIONAL)
While the very first drops of Skywell water will be clean, fresh water, the first few gall-
ons may have a less than optimal taste while the filters break in. In order to avoid
this Skywell recommends that the first 10 gallons produced not be consumed. (Feel
free to water plants or otherwise use the water as you see fit.) After the first ten gall-
ons, or the cold tank filling twice and being completely dispensed, the filters will
have had ample water passed through them for a complete break-in. Your Skywell
water will now not only be clean and fresh, but taste pure, without the potential
chalkiness associated with brand new water filters.
Dispensing Cold Water
Note: After setup, it will take up to 6 hours to get the water to its maximum cold
temperature. During this time, the compressor may run continuously. Cold water
availability for dispense will bealigned with overall water production, which is driven
by the ambient conditions.
1. Position your bottle, glass, pitcher or cooking pot securely below
the dispensing point indicated by the Skywell Mark at the front
of the machine.
• To avoid splashes, hold the cup as close to the tap as possible.
2. Press and hold the cold water control downward to start
dispensing water.
3. Release the control once the desired fill level is achieved.
Dispensing Hot Water
Note: After setup, the Skywell is able to heat generated water to
hot water (up to 207degrees Fahrenheit) within 15-20 minutes. Hot
water availability for dispense will be aligned with overall water
production, which is driven by the ambient conditions.
1. Position your bottle, glass, pitcher or cooking pot securely below
the dispensing point indicated by the Skywell Mark at the front
of the machine.
2. Press the red unlock button to unlock hot water dispensing (you
should hear a beep)
3. Press and hold the hot water button to start dispensing water.
4. Release the control once the desired fill level is achieved.
OPERATING AND USING YOUR SKYWELL