Figure 1 Elevation View to Satellite
Selection of Mounting Surface
The installation must be on a flat horizontal surface. The DMR-200C should not be mounted in an area where
standing water may occur. The drain holes in the slots on the bottom of the terminal should not be blocked.
The DMR-200C’s mounting surface must be capable of mechanically supporting the terminal. If not, a backing
plate (not supplied) or other suitable reinforcement should be employed.
In some cases, the surface temperature of the mounting platform may exceed the DMR-200C’s maximum
operating temperature (70C). If this is the case, the DMR-200C needs to be mounted with a thermal barrier
between it and the mounting surface.
Before drilling any holes, verify that there is enough space to accommodate the bend radius of the DMR-200C
Cable. The bend radius needs to be measured on the cable supplied with the DMR-200C.
Installation
Once the mounting location has been selected, the DMR-200C needs to be mounted. Select either Bottom
Connector Mounting (Figure 2) or the Side Connector Mounting (Figure 3) depending on the installation type.
In some cases, the Solution Provider may provide the DMR-200C with a mounting bracket. In this case, the
following instructions are not required. Refer to the instructions with the mounting bracket.
1)
Use the Drill Template (see figure 4) to mark the location of the four mounting holes and the connector
hole. The orientation of the terminal with a bottom connector is not important.
2)
Drill the four mounting holes using the drill with the 5.5 mm bit.
3)
Punch or drill the 25 mm hole for the connector. [Bottom Connector Mount Only]
4)
Run two concentric beads (2.0 cm and 3.5 cm from center hole) of waterproof sealing compound
around the connector hole. Be careful not to block the drain holes in the slots on the bottom of the
terminal. [Bottom Connector Mount Only]
5)
Secure the terminal in place with the mounting hardware using the screw driver and socket set,
6)
Install the mating connector and cable.
7)
Wrap the mating connector with waterproof sealing tape [If connector is exposed to elements].
