TRAMPOLINE ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
•
Need phillips screw driver and 2 adjustable wrenches (putting the trampoline together). A rubber mallet may make assembly
easier, however.
•
Assembly requires two persons.
•
Wear gloves to protect your hands from pinch points during assembly.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface before using it.
2. Adequate overhead clearance is essential. A minimum of 24 feet from ground level is best. Provide clearance for wires, tree
limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline away from walls, struc-
tures, fences, and other play areas. Always have a clear space on all sides of the trampoline.
3. Use the trampoline in a well-lighted area. Electric lights may be required for shady areas.
4. Secure the trampoline against unauthorized and unsupervised use.
5. Remove any objects from beneath the trampoline.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
15
Holes
Inside
11
12
12
13
16
16
16
16
14
14
14
25
24
4
11
4
1. Identify one Left Frame Tube(4) which has a sticker
“L”. Orient one Straight Frame Tube(11) as shown so
that the indicated holes are closer to the inner edge of
Straight Frame Tube with Sockets. Matches hole
pattern on connecting frame tubes( 4, 3 ).
Then connect the Left Frame Tube and the Straight
Frame Tube with Sockets by inserting Inner U-joint
(25), two M10x90mm Bolts (12), four M10
Washers(16) and two M10 Locknuts(14).
Make sure orient the Inner U-joint as shown.
Do not tighten the Locknuts.
2. Secure the connection between the Left Frame
Tube(4) and Straight Frame Tube with Socket(11)
with an Outer U-Joint(24), two M10x98mm Bolts(13)
and two M10 Locknuts(14).
Do not tighten the Locknut.
