Safety Note: Do not use the trampoline without the
Frame Pad. The Frame Pad is designed to reduce the pos-
sibility of injuries due to jumpers coming in contact with
the trampoline frame. If you do not have a Frame Pad,
contact your dealer to obtain one. Properly install the
Frame Pad before using the trampoline.
7. Look under the trampoline pad and locate the straps
and sleeves attached to the underside of the Frame Pad.
Position each outer strap so that one strap is on each side
of the frame as shown. Position each sleeve above a
spring, disconnect the spring, slide the spring through the
sleeve, and reattach to frame as shown.
Repeat this with the remaining sleeves (not shown).
Refer to the inset drawing. Hold one of the straps. Wrap
the longer strap under the frame and then thread the strap
through the buckle on the shorter strap as shown. Pull the
end of the longer strap to tighten straps. Do not overtight-
en the straps. Leave 1/4 inch gap.
Repeat this step with the remaining straps (not shown).
8. Using the included plastic tie, attach the Safety Placard
(6) to the frame near the point where jumpers will climb
onto and off the trampoline.
The trampoline is now fully assembled. Make sure that
all parts are securely attached. Familiarize yourself and
all users of the trampoline with the safety precautions,
use and instructional materials, and care and maintenance
instructions in this manual before using the trampoline.
14
DISASSEMBLY (TAKING APART)
To disassemble (take apart) the trampoline, follow assembly steps 1 through 8 in reverse order. Do not attempt to
disassemble any frame parts before the springs and the mat have been removed. Use gloves to protect your hands
from pinch points while taking the trampoline apart.
