4. Locate one strap(11) with D-rings to the upper edge of
the Netting. Lift the end of the strap(11) and insert it
through the small belt sewn on the upper edge of the
netting,see the right drawing. Then Lift D-ring and hold
it close to an L-tube(7)as shown in Inset Drawing A. Next,
thread the end of the Strap under the Foam Sleeve (9) on
the L-tube (7) and up through the two D-rings on the
opposite end of the Strap (11). (See Inset Drawing B.)
Then thread the end of the Strap (11) back down through
the lower D-ring on the Strap. (See Inset Drawing C.)
Pull the loose end of the Strap to remove any slack but
do not fully tighten the Strap (11) at this time.
Attach the Netting (10) to the other seven L-tubes (7)
with the other seven Straps (11) in the same manner.
5. Tighten the eight Straps (11) attaching the Netting (10)
to the L-tubes (7). (See Step 4.)
Tie the free end of each Strap (11) around the rest of the
Strap (11) to prevent the Strap from becoming loose.
6. Tighten the Straps (not shown) on the underside
of the frame pad. See Trampoline manual page 14.
7. Now insert the plastic cap into the bottom of the T-
Bracket.
Your trampoline enclosure is now fully assembled (put
together). Make sure that all parts are securely attached.
Familiarize yourself and all users of the trampoline and
enclosure with the safety precautions, use and instruction-
al materials, and care and maintenance instructions in this
manual before using the trampoline and enclosure.
10
Door
D-ring
8
10
7
11
11
11
7
9
10
Inset Drawing A
B
C
Insert plastic cap into end of T-Bracket
small belt
11
7, 8
