3.
Note: This step requires two persons
. During this
step, you will connect the four assembled leg sections
with the remaining four Top Tubes (1).
Stand two leg sections and hold them in the positions
shown. Slide the large end of one of the remaining Top
Tubes (1) onto the small end of the indicated Top Tube
on one of the leg sections. Insert the small end of the Top
Tube into the indicated Socket (2) on the other leg sec-
tion. Repeat this step until all four leg sections are con-
nected. When this step is completed, the frame will be
fully assembled and freestanding.
4. Lay the Bed (Mat) (5) on the ground inside the assem-
bled frame. Make sure that the two warning decals (not
shown) are on top of the Bed (Mat).
Note: If you purchased the Skywalker Trampoline
Combo, the enclosure was pre-installed on the Bed (Mat)
(5) at the factory. Inspect the attachments of the enclosure
Netting to the trampoline mat (bed). Make certain each of
the V-rings on the trampoline mat (bed) is threaded
through the corresponding “buttonhole” in the Netting.
Be sure to place the opening in the Netting so it is cen-
tered under the arch where the jumpers will climb off of
and onto the trampoline. If you did not purchase a
Trampoline enclosure, disregard this paragraph.
Note: There are 80 V-rings around the edge of the Bed
(Mat) (5) and 80 holes around the top of the frame. In
Steps 4 and 5 you will attach the Bed (Mat) (5) to the
frame, using 80 Springs (7).
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful where you place your
hands as the Springs and frame joints can pinch.
12
1
2
Leg Section
Leg Section
Small
End
Small
End
Large
End
5
7
7
7
7
V-rings
Align opening of enclosure
as shown here, centered in
between the legs of the
trampoline.
V-rings
