Secure the frame with screws (part H) under
the C-2 parts, to hold together the top rail.
If you are unable to insert a
screw because the holes
are not aligned, wait until
after installing the mat, the
structure will realign then.
Add two stabilizers, part K,
to the bottom of each leg;
1 on each side of the leg.
Now, the frame assembly is complete.
Attach the Legs.
Note:
Step
4
Step
5
Step
6
Attach the leg supports you assembled in
step 3 to the top rails C-1. Each leg
attaches to 2 different C-1 parts,
straddling the C-2 part, as shown in the
image. Repeat with all legs until you have
the full frame standing.
Secure the Legs
Secure the leg
supports to the
top rail frame with
screws- part H,
fastening tightly.
Secure the Frame
How To Use The Spring Pulling Tool
Step I:
Hook the more rounded end of the spring
onto the trampoline mat's triangular rings.
Step II:
Extend the spring pull tool and link it up
with the other end of the spring. Pull the tool in
the direction of the trampoline frame until the
spring head is lined up with the hole in the
trampoline frame.
WARNING:
Be careful where you place your hands during spring assembly as
connector points can pinch!
Make sure the v-rings between the springs matches the number of holes in the
frame between the springs.
Note:
Lay out the trampoline mat inside the frame.
1.
Connect 4 springs between the mat and the rail, at the 1/4 way points in the
circle, as in the figure below. Attach the rest of the springs according to the
steps outlined below.
2.
TRAMPOLINE MAT ASSEMBLY
First connect the 4 springs
at the 1/4 points.
Follow by connecting
4 additional springs
in the center of the quarters.
Then continue,
connecting every
few springs
Complete the
rest of the springs
Step III:
Slide the spring end into the hole as
you remove the tool.
