ROOM
TEMP
TEMP
SET
ROOM
TEMP
THERMOSTAT FUNCTION
NOTE: The thermo feature operates the appliance whenever the room temperature varies a certain number of degrees from the set
temperature. This variation is called the “swing” or temperature differential. This feature lets the appliance turn off and on 2 ºF (1 ºC)
above or below the set temperature of the room. This is to cushion the number of times the appliance is turned on and off.
THERMO UPDATING FEATURE - TRANSMITTER
When in thermo mode, the transmitter reads the ROOM temperature every 2 minutes, checks the room temperature against the SET
temperature then sends a signal to the receiver.
THERMO MODE
THERMO SET
THERMO ON
THERMO OFF
RECEIVER
Install the 4 AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be used for this product.
Be
sure the batteries are installed with the (+) and (-) ends facing the correct direction.
ON
: will manually turn on appliance.
REMOTE
: will allow use of handheld transmitter. If the system does not respond
to the transmitter on initial use, check the battery positions in the remote. If that
does not work, see the SECURITY CODE section.
OFF
: will disable the remote receiver.
It is suggested that the slide switch be placed in the OFF position if you will
be away from your home for an extended period of time.
REMOTE
N
O
F
F
O
LEARN
ADJ
.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole
Remote Receiver
Batt
ery co
ver s
lides o
n/off
Slide
Switch
ON
REMOTE
OFF
The remote receiver has a 3-position slide switch for selecting the mode of operation
ON/REMOTE/OFF
INSTALLATION
The remote receiver can be either wall-mounted in a standard plastic switch bo
[
(not metal) or placed on or near the
¿
replace hearth.
Preferably, the remote receiver should be wall-mounted in a plastic switch box, as this will protect its electronic components from the
heat produced by the gas appliance. The remote receiver should be kept away from temperatures exceeding 130º F. Battery life is
also signi
¿
cantly shortened if batteries are exposed to temperatures 130ºF or higher.
Before installation make sure the remote receiver slide switch is in the
OFF
position. After installation be sure that the slide switch be
moved to the
REMOTE
position.
MOUNTING THE REMOTE RECEIVER
WALL MOUNT
When wall mounting the remote receiver, longer wires (not included) are required to connect to the gas valve or electronic module.
These wires must:
Be at least 18 Gauge (AWG)
Be no longer than 20’
Have no splices
Press the
MODE
key until the LCD screen shows the word “ROOM.”
(See Thermo Mode graphic)
To adjust set temperature, press and hold the
SET
key until the de-
sired temperature is reached. The temperature range is 99ºF (32ºC)
to 45ºF (6ºC). (See Thermo Set graphic)
The LCD screen will display the set temperature for 3 seconds, then
it will
À
ash the set temperature for 3 seconds. It will default to show
the room temperature.
The
À
ame icon will appear when the control calls for heat. (See
Thermo On graphic). The
À
ame icon will disappear when the appli-
ance reaches its set temperature. (See Thermo Off graphic).
Press the
MODE
key to disengage the Thermo Mode. “ROOM” will
disappear from the LCD screen.
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before at-
tempting installation. Follow instructions carefully during installation. Any modi
¿
cations of this remote control or any of its compo-
nents will void the warranty and may pose a
¿
re hazard.
Consult gas appliance manufacturer’s instructions and wiring schematics for proper placement of all wires. All electronic modules
are to be wired to manufacturer’s speci
¿
cations.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/or electronic
module for correct wiring procedures. Improper installation of electric components can cause damage to electronic module, gas
valve and remote receiver.
ROOM
TEMP
Allparts Equipment Inc 1-877-475-5660 www.allpartsinc.com October, 2011
