___________________________________________________________________________________________________________
Rev
.
7/10/15 Page 3 of 5
Skytech RCAF-LMF-1
POWER SETTING – RCAF-LMF
The RECEIVER comes from the factory programmed to provide pulse DC voltage (5.5) VDC to 6.3 VDC) to a latching solenoid.
REMOTE RECEIVER
IMPORTANT
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT
TEMPERATURES DO NOT EXCEED 130° F.
The remote receiver (right) operates on (4) 1.5V AA-size batteries. It is
recommended that ALKALINE batteries be used for longer battery life and
maximum microprocessor performance. IMPORTANT: New or fully charged
batteries are essential to proper operation of the remote receiver as a latching
solenoid power consumption is substantially higher than standard remote control
systems.
NOTE
: The remote receiver will only respond to the transmitter when the 2-position slide
button on the remote receiver is in the REMOTE position. The remote receiver houses
the microprocessor that responds to commands from the transmitter to control system
operation.
FUNCTIONS:
•
With the slide switch in the ON position (toward the LEARN button), the system will
remain on until the slide switch is placed in the OFF or REMOTE position.
•
With the slide switch in the REMOTE position (centered), the system will only operate
if the remote receiver receives commands
from the transmitter.
•
With the slide switch in the OFF position (away from the LEARN button), the system
is OFF.
•
It is suggested that the slide switch be placed in the OFF position if you will be
away from your home for an extended period of time. If the remote receiver is
mounted out of children’s reach, placing the slide switch in the OFF position
also functions as a safety “lock-out” by both turning the system off and
rendering the remote receiver inoperative.
INSTALLATION INSTRUCTIONS
WARNING
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR
CORRECT WIRING PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC COMPONENTS
CAN CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
INSTALLATION
The remote receiver can be mounted on or near the fireplace hearth. PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT.
Like any piece of electronic equipment, the remote receiver should be kept away from temperatures exceeding 130º F inside the
receiver case. Battery life is also significantly shortened if batteries are exposed to high temperatures.
Make sure the remote receiver switch is in the OFF position. For best results it is recommended that 18 gauge stranded wires should
be used to make connections and no longer than 20-feet.
www.FireplaceRemoteControls.com
1.888.977.6849
