FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES
(855) 498-8324 or (260) 459-1703
For Sales: (888) 672-8929
Web site: www.skytechpg.com
CANADIAN INQUIRIES
(877) 472-3923
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided.
•
Wood - Drill 1/8’’ pilot holes and install with screws provided.
•
Plaster/Wallboard - Drill 1/4’’ holes, use a hammer to tap in the two plastic anchors, then
install with the screws provided.
WALL CLIP
SLOT
WALL CLIP
BATTERY
COMPARTMENT
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter and receiver should be at least 12 months. Check and replace all batteries:
•
Annually.
•
When operating range becomes reduced.
•
When transmissions are not received by the remote receiver.
•
If the remote receiver batteries measure less than 5.3 volts (all four batteries in combination).
•
If the hand held transmitter battery measure less than 9.0 volts.
TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with either the fireplace itself or with the remote. Review
the fireplace manufacturer’s operation manual to make sure all connections are properly made. Then check the operation of the
remote in the following manner:
•
Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully charged.
•
Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure receiver and transmitter is within 20-25 feet operating range.
•
Keep receiver from temperatures exceeding 130
°
F. Battery life will be shortened if exposed to high temperatures.
•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
•
Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING TRANSMITTER TO
RECEIVER section).
•
Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will not
allow any more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide switch into the
REMOTE position. Press the learn button and release after 10 seconds. You should hear three (3) long audible beeps indicating
all codes have cleared. You can now “learn” the transmitter to the receiver as described in the General Information Section.
Skytech 1001-A
REV. 11-8-16 Page 4
