Mounting the Colour Wheel
-
Unscrew the nut and the first tooth ring from the fixation axle of the colour wheel motor.
-
Remove the foil of the colour wheel.
-
Slip the colour wheel onto the fixation axle of the motor
-
Slip the tooth ring first and then the nut onto the fixation axle.
-
Fasten the nut without damaging the colour wheel.
-
Fix the colour wheel with motor via the fixation on the motor to the pin spot housing and
tighten the screw.
Rigging
-
Mount the Pin spot with the mounting-bracket to your trussing system using an appropriate
clamp. The hole in the mounting bracket has a diameter of 10mm.
-
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the
fixture. You must only use safety-ropes with screw-on carabines. Pull the safety-rope through
the hole in the mounting bracket and over the trussing system. Insert the end in the carabine
and tighten the fixation screw.
-
Adjust the desired inclination-angle via the mounting bracket and fix the bracket screws tightly.
-
Connect the fixture to the mains with the power plug.
Technical specifications:
MIRROR BALL MOTOR
Power supply: ..................................................................................... 230Vac / 50Hz
Power consumption: ............................................................................................ 4 W
Max Charge: ........................................................................................................ 3 kg
Max. Dia. of mirror ball: .................................................................................... 30 cm
Rotation speed: ................................................................................................ 5 rpm
Diameter of base plate: ................................................................................. 110 mm
Height: ............................................................................................................. 58 mm
Weight: .............................................................................................................. 0.3 kg
Pin spot Par 36
Power Supply:..................................................................................... 230Vac / 50Hz
Power consumption: .......................................................................................... 30 W
Weight: .................................................................................................................. 1 kg
Dimensions (LxWxH): ................................................................. 150 x 120 x 115 mm
Fitting Lamp: ...................................................................................... 6V 30W Par 36
Colour wheel with Motor
Power supply: .................................................................................... 230Vac / 50Hz
Rotation speed: ............................................................................................. 2.5 rpm
Colours: ............................................................................... Red, green, yellow, blue
Diameter: .......................................................................................................... 23 cm
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings
contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations and
warnings. This is also applicable to all damages in whatever form.
