·
12
Ultimate Duo 1400W
OPERATING PROGRAM
Locate the flowcharts show the entire programming menu. It is highly recommended to
have these flowcharts handy while learning to operate this charger.
There are two main ways in which to set the charger.
A memory profile is available for setting and storing pertinent information for up to
10 different batteries. Once a battery's information is stored into a memory it will be
retained until changed again manually. Recalling a battery's memory number
makes the charger instantly ready to go!
If you do not wish to use the battery memories, this charger can be manually set
before each use.
2. Getting started
(1)
(2)
For following step, all are basing on manually set
3. BATT/PROGRAM Select
B A T T / P R O G R A M
L i P o B A T T
4. Mode Select
6. Program Start
L i P o B A L A N C E C H G
2 . 0 A 1 1 . 1 V ( 3 S )
Press INC and DEC to go through all the programs and press
START/ENTER to enter LiPo BATT Program.
5. Battery Setting
L i P o B A L A N C E C H G
2 . 0 A 1 1 . 1 V ( 3 S )
Press INC and DEC to go through all the modes and press
START/ENTER to enter LiPo Balance Charge Mode.
Press START/ENTER, the current value will start to blink, press
INC and DEC to change the value and press START/ENTER to
confirm your setting.
At the same time, the battery cells number will start to blink,
press INC and DEC to change the value and press
START/ENTER to confirm your setting.
L i P o B A L A N C E C H G
2 . 0 A 1 1 . 1 V ( 3 S )
B A T T E R Y C H E C K
W A I T . . .
L i P o B A L A N C E C H G
2 . 0 A 1 1 . 1 V ( 3 S )
Press and hold START/ENTER for 3 seconds to start the
program.
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S is
the number of cells set by you at the previous screen. If both
numbers are not identical, press STOP to go back to previous
screen to recheck the number of cells of the battery pack before
going ahead.
R : 3 S E R S : 3 S E R
C A N C E L ( S T O P )
START/ENTER
START/ENTER
START/ENTER
START/ENTER
START/ENTER
> 3 Seconds
