6
Picture - 06
Adjust Handle
3.3 Cleaning
3.2 Dough thickness adjustment
To choose the dough thickness, turn the handle until the desired
thickness.
IMPORTANT
Never clean the machine when it is turned on or plugged. To do so,
unplug the machine from the socket.
Before removing the protection lids, make sure the rolls have come
to a complete stop.
To clean the machine, first unplug it from the electric socket. All the
parts in contact to the dough must be cleaned.
After, we will describe the procedure to be followed in order to open the
protection.
3.3.1 When the machine is turned off and the rolls are motionless,
remove the knurled knobs, which hold the protection plate ,then remove
the protection plate.
IMPORTANT
Read carefully and with attention the INSTRUCTIONS of this
manual before turning on the machine. Make sure you
understand all the information thoroughly. In case of doubt (s),
contact your manager or Distributor.
9
4.1.2 Warnings
The operator has to be well familiar with the position of the ON/OFF
Switch, in order to make sure it is easy to reach when necessary.
Before any kind of maintenance, physically unplug the machine from the
socket.
Provide enough space for a comfortable operation thus avoiding
accidents.
Water or oil spilled on the floor will make it slippery and dangerous. Make
sure the floor is clean and dry.
Never touch or activate any manual command (switches, buttons or
levers) unnecessarily.
I
f any work is to be made by two or more persons, coordination signs must
be given for each operation step. Every step of the operation shall be taken only if
a sign has been made and responded.
4.1.3 Advices
In case of power shortage, immediately turn the machine OFF.
Use recommended or equivalent lubricants, oils or greases.
Avoid mechanical shocks, once they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical and electrical
components of the machine.
DO NOT modify original characteristics of the machine.
DO NOT remove, tear off or maculate any safety or identification labels of
the machine. If any label has been removed or is no longer legible, contact your
nearest dealer for replacement.
4.2 Cautions and notes before turning the machine on
4.2.1 Danger
Electric cables or wires with damaged jacket or bad insulation can cause electrical
shocks as well as electrical leak. Before use, check conditions of all wires and
cables.
