5
Picture - 04
Wrong
Picture - 05
Right
2.3 Feeding procedure
The dough must be put on the feeding tray until it is pulled by the rolls.
Be careful so that your hand does not pass through the upper roll protection.
IMPORTANT
Never use your hands to put or remove any dough between the
rolls.
3. Operation
3.1 Starting
Be sure that all the protections are appropriately fixed on the
machine. To start the machine use the ON / OFF switch, located on the
upper part of the housing. If the machine does not turn on, check if the
emergency button is activated. If it is, turn it clockwise in order to unlock it.
The Laminator Dough Roll CMF-300 is equipped with protections
that prevent user from accessing the spinning parts of the machine and also
a safety system, which immediately stops the rolls.
IMPORTANT
Wait until the rolls come to a complete stop, before removing the
protections. Do not place objects such as knifes, spoons and others
upon the feeding tray, especially with the machine turned off.
10
4.2.2 Advices
Be sure that ALL INSTRUCTIONS in this manual have been thoroughly
understood. Every function and operational procedure must be very clear to the
operator.
Any manual command (switch, button or lever) shall be given only after
being sure it is the correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power consumed by the
machine.
Cables touching the floor or close to the machine need to be protected
against short circuits.
4.3 Routine Inspection
4.3.1 Advice
When checking the tension of belts or chains, DO NOT introduce your
fingers between the belts, the chains nor between the gears.
4.3.2 Precautions
Check motor (s), belt (s), chain (s), gear (s) and sliding or spinning parts of
the machine if there is any abnormal noise.
Check the tension of the belts and chains and replace the set when they
show any signs of wearing.
When checking tension of belts or chains, DO NOT introduce your fingers
between belts and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.
4.4 Operation
4.4.1 Advice
Do not operate the machine with long and loose hair touching any part of
the machine, because it can lead to a serious accident. Tie your hair well up and/or
cover your hair with a scarf.
The operation performed by not trained or skilled personnel shall be
forbidden.
NEVER operate machine without all original safety devices under perfect
conditions.
