18
TABLE 02
PROBLEM
CAUSE
SOLUTION
- The equipment does not
start.
- Energy shortage;
- Problem with the electric
circuit.
- Check energy supply;
- Call Technical Assistance.
- Burn smell or smoke.
- Problem with the electric
circuit.
- Call Technical Assistance.
- The equipment switches ON
but when the product is
placed inside the cup the knife
stops or turns slowly..
- Problem with the motor.
- Call Technical Assistance.
- Damaged Cord.
- Problem during transporta
ti
on. - Call Technical Assistance.
- Strange noises.
- Damaged bearing.
- Call Technical Assistance.
- The product does not Blend.
- Product pieces too large.
- Blunt knife.
- Cut product pieces 3.5 cm
wide.
- Call Technical Assistance.
- Cup leaking.
- Damaged sealing.
- Call Technical Assistance.
7
TABLE 01
CHARACTERISTICS
UNIT
LT-2,0 SUPER-N
Maximum Capacity of Cup
l
2
Voltage
V
110
Frequency
Hz
50 ~ 60
Power Ra
ti
ng
W
1500
Height
mm
495
Width
mm
205
Depth
mm
235
Net Weight
kg
4,2
Gross Weight
kg
5,2
1.3 Technical Characteris
ti
cs
2. Installa
ti
on and Pre Opera
ti
on
2.1 Installa
ti
on
2.1.1 Placing
The Blender is to be installed onto a leveled dry surface approximately 850mm high.
2.1.2 Electrical Installa
ti
on
This equipment was developed to be used with: 110V voltage. Upon receiving the Blender
control the voltage indicated on the cord label.
The cord has a plug with three pins, the middle one is grounding. It is mandatory the three
pins to be connected before to start to use the blender.
