10
IMPORTANT
DO NOT USE THE BLENDER TO PROCESS DENSE PRODUCTS.
IMPORTANT
The blending process
ti
me changes from product to product. It is not
recommended to blend solid products without to add some liquid , because
overhea
ti
ng may occur , following damages to the cup sealing.
IMPORTANT
NEVER SWITCH “ON” THE BLENDER WITH AN EMPTY CUP , BECAUSE IRREPARABLE
DAMAGE WILL OCCUR.
Consider the maximum level indicated on the Cup # 01 (pic.04) below.
Place the Lid # 02 (Pic.01) with the Cap # 01 (Pic.01) in accordance with item 2.2.2 and
2.2.3 , then switch the blender ON.
PICTURE 04
IMPORTANT
Cut the product in small pieces approximately 3.5 cm wide, it will help to reduce
the blending
ti
me par
ti
cularly with frozen products. When processing ice, it is
recommended to add some water.
01
15
4.3 Rou
ti
ne Inspec
ti
on
4.3.1 Advice
When checking the tension of the belts or chains, DO NOT insert your fingers between the
belts and the pulleys and nor between the chain and the gears.
4.3.2 Precau
ti
ons
Check the motor and sliding or turning parts of the machine in case of abnormal noises.
Check the tension of the belts and chains and replace the set when belts or chains show
signs of wearing.
When checking the tension of belts or chains DO NOT insert your fingers between belts
and pulleys, nor between the chains and gears.
Check protec
ti
ons and safety devices to make sure they are working properly.
4.4 Opera
ti
on
4.4.1 Warnings
Do not use the machine with long hair that could touch any part of the machine. This might
lead to a serious accident. Tie your hair up well and/or cover it with a scarf.
- Only trained or skilled personnel shall operate this machine.
- Never touch turning parts with your hands or any other way.
- NEVER operate the machine without any original safety devices under perfect condi
ti
ons.
4.5 A
fter Finishing The Work
4.5.1 Precau
ti
ons
Always TURN THE MACHINE OFF before cleaning by removing the plug from the socket.
Never clean the machine unless it has come to a complete stop.
Put all the components back to their func
ti
onal posi
ti
ons before turning the machine ON
again.
Check the level of oil.
Do NOT insert your fingers in between belts and pulleys nor chains and gears.
4.6 Maintenance
