Assembly & Operation Manual
ELEVATORS & RUDDER
NOTE:
Use some protective foam on the work bench to protect the paint surface from
unwanted dents. A removable elevator mechanism is installed. Mark √ each step.
Fit servo horn and centre servo using radio. Remove horn. Mark location of horn.
Dremel hole to clear horn, refit horn.
Fit horn to servo bracket via root of stab.
Mark location for elevator horn.
Cut slot for horn.
Glue horn with 5 minute epoxy. Make sure the horn is glued into balsa block lo-
cated inside elevator.
Secure pushrod.
Repeat for other stab and Fin.
Fit stab with 2 carbon rods and secure with bolts
Fit fin and secure by clamping carbon rod.
Run 3 servo wires neatly in rear fuselage.
P-12
Photo 15
Photo 16
