Assembly & Operation Manual
FIN & RUDDER
NOTE:
Make sure to have some sort of protective
foam on the work bench. This will protect the paint
surface from unwanted dents. Mark √ each step.
Locate all parts needed
for this section.
Make up rudder push-
rod.
Fit wire
belcrank in position. Fit belcrank over
wire and mark location of set srews.
Cut flat sections into wire and secure belcrank to wire with
loctide.
Fit servo to servo plate.
Feed pushrod through formers and secure pushrod to ser-
vo horn and belcrank. Use safety clips.
Make sure servo
horn and belcrank
form 90 degree angle.
Mark location of
pin hinges and cut
slots for hinges.
Note—the pivot point
is inside rudder lead-
ing edge.
Glue hinges to fin
and rudder.
Trial fit fin and rudder. If happy fin to fuselage.
NOTE: If fin is removable secure fin with cap screws located on 2 clamps.
P-17
Photo 38
Photo 39
Photo 36
Photo 37
Photo 40
