Assembly & Operation Manual
STABILIZERS
Feed pushrods through formers and secure to belcranks. Use safety clips.
Fit L-brackets to 2 x DS8511 servos.
Secure servos back to back on servo mount.
Secure pushrods to servos.
Check operation of elevator servos.
Make sure no slop in system.
Fit stabilizers to fuselage. The wire belcrank
must fit in slot to side of elevator. Check for
no slop. Check movement of elevators.
If you want to
make stabilizer
removable, you will need to drill 2mm holes in
brass tubing holding carbon spar. Fit 2mm bolt
to hold stabilizer in position.
If you do not want to make stabilizer remova-
ble then simply glue stabilizer to fuselage and glue the wire belcrank to elevator.
NOTE : If you glue stabilizers it will not be possible to make fin removable. Fin will also
be glued to fuselage.
P-16
Photo 33
Photo 34
Photo 35
