PN 38035_C
page 6 of 9
©2018 Skyline Exhibits TradeWinds® is a registered trademark of Skyline Exhibits
Tradewinds Immerse™ Display System Setup Instructions
Front/Back
Monitor Mount
1. Identify the nylon strap and four
additional internal connectors
2. Locate the inner side of the
column where you want to
mount your monitor and screw
one internal connector into the
front/
top
frame hub.
3. On the front/
back
side of the
frame, thread the screw of the
opposite internal connector
through the nylon strap and
screw into the frame hub.
4. Repeat steps 2 and 3 on the
bottom of the frame so the
strap runs the full height of the
frame. This is best done with
the frame partially opened.
Once you have installed the monitor
strap and internal connectors, you do
not need to uninstall them each time
you set up your frame.
5. Identify the monitor mounting
plate and support hooks.
6. Match support hooks #1 &
#2 with their corresponding
locations labeled on the
mounitng plate. Attach the
support hooks to the mounting
plate using the provided thumb
screws.
7. Hang the assembled monitor
mount on the front side of the
frame by first hooking to the
top cross braces, and then lower
the mount onto the bottom
cross braces. Referrence the “Up”
and “Down” labels on the mount
for correct hanging orientation.
Nylon Strap
Nylon Strap
Monitor
Mount
Frame
Hub
Frame Hub
Front
Back
Internal Connectors
Top Cross Brace
Bottom Cross Brace
Front
Back side of frame
Accessory Foot
Front/Top
