163
SJ82 T, SJ86 T
229040ABA
General
Section 5 – Procedures
6.
Continue to slide the support bar in. Set the
boss end in the notch in the opposite turret wall.
Note: The boss must be on the inside of the
turret.
7.
Push the lock-pin through the hole in the
maintenance support. Make sure the detent ball
comes all the way out the other side.
IMPORTANT
Do not lower the main lift cylinder onto the
maintenance support bar. The bottom of the
cylinder should stop just above the support.
To
order
go
to
Discount-Equipment.com
