1. The pouch laminator must be connected to a supply voltage
corresponding to the electrical rating of the machine as indicated.
2. Unplug the pouch laminator before moving it, or when it is not in use for
an extended period of time.
3. Do not operate with a damaged supply cord or plug, after it
malfunctions, or after it has been damaged in any manner.
4. Do not overload electrical outlets beyond their capacity as this can
result in fire or electrical shock.
5. Do not alter attachment plug, plug is configured for the appropriate
electrical supply.
6. The unit is intended for indoor use only.
1 Specifications
2 Electrical Safeguards
3 Trouble Shooting Guide
4 After Sales Service Information
Max. Laminating Width
335 mm
490 mm
Max. Laminating Speed
1400 mm
1200 mm
Max. Pouch Thickness
350 MIC
Max. Laminating Thickness
3 mm
Heating System
Heating roller internal heater
Q ty of Roller
6
Operating Temp.
0
- 140
Temperature & Speed Control
Yes
Preheating Time
6 mins
Power Consumption
1150 watt
Rating
230V / 60Hz / 6A
Dimension
536 x 271 x 112 / 15kg
690 x 271 x 112 / 20kg
Machine has no
power or rollers are
not rolling
Excessive noise
Bad lamination
No increase of Temp
Corner is not sealed
Emergency state
Power code is not
properly plugged in
Power switch off
Operation of gear is not
smooth.
Laminated document
wrinkled, damp, or folded
Check power plug
Document is too thick to
seal the edges of the film
Something may be stuck
Between the heated
rollers or they are out of
position
Check the power plug
is properly plugged
Check the power
switch is turned on
or contact support
Turn off the machine,
and then contact A/S
Adjust the temperature
lower or higher
Check if the power plug
and switch is turned on
or contact support
Use a thinner document
or leave more around
the edges, aprox. 5mm
Turn off the switch
Contact A/S
If you have any problem can not be solved at your end, please contact;
The telephone number is on the label on the back side of machine.
2
3
Problem
Cause
Solution
Summary of Contents for R6
Page 1: ......
