01742
CONTROLLER ASSEMBLY
STUNT DRONE BUILDER
E1700
Insert the AAA batteries into the battery compartment. Insert the battery cover
onto the controller housing and secure with the screw.
Place the battery compartment insert into the battery box and secure with
2 type D screws. Secure the back of the controller housing to the front controller
housing using 4 type D screws.
Connect the two joystick thumb pads or pro style thumb sticks.
STEP FIVE
STEP SIX
STEP SEVEN
STEP THREE
STEP FOUR
STEP ONE
STEP TWO
Press the left and right joysticks covers down onto the joysticks. Press the
sensitivity switch down on to the sensitivity slider.
Place the front housing of the controller face down on a table. Now start placing
the buttons into their relevant sockets ensuring each is seated around their
appropriate guide pins.
Insert the antenna housing into the front controller housing. Place the transmitter
circuit board into the front housing ensuring that the guide ports fit through the
holes on the board. Finally attach the transmitter circuit board to the front
housing using 2 type C screws.
Insert the stunt button circuit board into the front controller housing and push
into place until seated. Insert the power plug into the connector socket on the
back-controller housing.
