AAA BATTERY CAUTIONS
• Do not use rechargeable batteries.
• Different types of batteries or new and old batteries are not to be mixed.
• Batteries are to be inserted using correct polarity.
• Remove exhausted batteries as soon as possible and discard properly.
• Remove all batteries from compartment if toy is not used for a long period of time.
• Never throw batteries in a fire or attempt to open the outer casing.
• Non-rechargeable batteries are not to be recharged.
• The supply terminals are not to be short circuited.
• Batteries should be replaced by an adult.
WARNING
: Batteries are harmful if swallowed. Please keep away from children.
Battery Disposal: Dispose of batteries according to the local laws and regulations of your region. Some
batteries may be recycled, and may be accepted for disposal at your local recycling center. If you are not
able to identify the applicable rules in your area, please check the instructions of the battery manufacturer.
THIS PRODUCT CONTAINS A LITHIUM-POLYMER BATTERY 3.7V 650mAh
:
LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused. They may
explode, overheat or ignite. Read all following precautions and instructions regarding the care and use
of LiPo batteries.
The LiPo battery is only to be used with the drone and charger included with this product.
• Keep away from flammable materials.
• Do not expose to direct sunlight.
• Do not place in fire or leave in hot places.
• Do not drop or make subject to strong impact.
• Keep dry and away from water.
• Remove exhausted battery as soon as possible and discard properly.
• Remove battery from the compartment if toy is not used for a long period of time.
• The supply terminals are not to be short circuited.
• Never throw battery in a fire or attempt to open outer casing.
• Do not leave battery connected to drone when not in use.
LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly. They should not be
disposed of with other household waste. Check your local laws and regulations for correct recycling
and/or battery disposal.
Before each use, an adult should check this product and the LiPo battery to ensure no damage or hazards
exist. Drone has rotating blades that move at high speed, posing danger of damage and injury. Use of
included blade guards strongly recommended. Pilots are responsible for any actions that result in damage
or injury from the improper operation of drone. Adequate flying space is required. Avoid flying near interior
fans and/or vents as they may make flying difficult to control. Keep a safe distance away from streets,
public thoroughfares and power lines. Never attempt to retrieve drone from any location higher than your
reach (such as rooftops or trees) or from any location that poses a safety hazard. Never fly drone at night.
Keep drone in sight at all times during operation. Discontinue operation immediately if drone flies out of
your field of view. Do not fly near spectators or animals. Keep spinning rotors away from fingers, hair, eyes
and other body parts. Always launch from a flat surface. Never leave drone unattended while it is turned
on. Read all enclosed information before operating.
ADULT SUPERVISION REQUIRED
3 x1.5 V AAA (LR03)
+ A
A
A
/L
R
03
/R
03 1
.5
V –
+ A
A
A
/L
R
03
/R
03 1
.5
V –
– A
A
A
/L
R
03
/R
03 1
.5
V +
INSTALLING BATTERIES IN THE CONTROLLER
CHARGING THE LiPo BATTERY
CHARGING PRECAUTIONS:
• After use, allow drone (battery on bottom) to cool down to room temperature
before charging again.
• Charge battery in an isolated area, away from excessive heat or moisture.
• If you suspect that the battery is damaged or swelling, discard the battery in accordance with
your country’s recycling laws.
• Do not modify, heat, or wet the battery in any way. Only recharge with provided charger
Red light = charging
Green light = fully charged
*Screwdriver not included.
*Batteries not included.
Google Play and the Google Play logo are trademarks of Google Inc.
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S.
and other countries. App Store is a service mark of Apple Inc., registered in the
U.S. and other countries.
©2017 Skyrocket LLC, Los Angeles CA 90066 USA. All Rights Reserved. Sky
Viper and Skyrocket and their respective logos are trademarks and/or
registered trademarks of Skyrocket LLC. All other trademarks, logos and
copyrights are the property of their respective owners, and there is no
relationship express or implied with Skyrocket LLC.
MADE IN CHINA.
Remove all packaging attachments before giving the toy to a child.
Not suitable for children under 3 years due to small parts that could be swallowed.
Conforms to product safety standards ASTM F963.
Keep instructions for future reference. Do not discard.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV
technician for help.
The software included in this product contains copyrighted software that is licensed under the
GPLv3. A copy of that license is included in our website at the URL below. You may obtain the
complete Corresponding Source code from us for a period of three years after our last shipment of
this product and/or spare parts therefor, which will be no earlier than 05-01-2020, on our website at
http://www.skyviper.com/GPL/
LiPo BATTERY
Computer or
charging block.
TRIM ADJUSTMENTS AND CHARGING
STUNT DRONE BUILDER
E1700
SKY VIPER FLIGHT SIMULATOR
FAILSAFE GUIDE
Learn and practice maneuvers on your phone, then apply
your new skills in real life.
When the drone turns
upside down, the motors
will stop spinning.
When the drone goes out of
range of the controller, it will
automatically land itself in
its current position. If the
controller comes back in to
range before the drone
lands, it is possible to cancel
this automatic landing by
pressing up on the throttle.
When the drone's battery is
at 10% or less, the LEDs on
the drone will begin to blink
rapidly, and a tone is played
continuously on the
controller until the
controller and drone are
turned off.
When the drone's
battery is depleted, the
drone will automatical-
ly land itself in its
current position. This
automatic landing
cannot be interrupted
with the controller.
If the drone detects that no
input has been received by
the controller for 15
seconds, the drone will
automatically land itself in
its current position..
X
Double your flying time with an
additional battery!
Details of how to purchase additional or
replacement battery packs available at
SKYVIPER.COM
#01739
TRIM ADJUSTMENTS
IF THE DRONE DRIFTS FORWARD:
Press
"
B
" button several times until the drone
stops drifting forward.
IF THE DRONE DRIFTS BACKWARD:
Press "
F
" button several times until the
drone stops drifting backward.
IF THE DRONE DRIFTS LEFT:
Press
"
R
" button several times until the
drone stops drifting left.
IF THE DRONE DRIFTS RIGHT:
Press
"
L
" button several times until the
drone stops drifting right.
IF THE DRONE SPINS COUNTER-CLOCK-
WISE
(VIEWED FROM ABOVE)
:
Press the
button several times until the drone stops
spinning.
IF THE DRONE SPINS CLOCKWISE
(VIEWED FROM ABOVE)
:
Press the button
several times until the drone stops spinning.
When the controller is OFF, press and hold
the flight mode button, LAUNCH/LAND
button, and POWER button for three
seconds to toggle between mode 1 and
mode 2.
Mode 2 (default, most commonly used)
LEFT thumb stick makes the drone go
up/down, and rotate
clockwise/counter-clockwise.
RIGHT thumb stick makes the drone fly
forward, backward, left, and right.
Mode 1 (used in Australia and most
Asian & European countries)
LEFT thumb stick makes the drone fly
forward/backward, and rotate
clockwise/counter-clockwise.
RIGHT thumb stick makes the drone go
up/down, and fly left and right.
CONTROLLER MODE
WE’RE HERE TO HELP
For questions about
this product:
Online:
skyviper.com/support
Phone:
1-888-674-5650
M-F 9am to 6pm PST
INSTALLING BATTERIES IN THE CONTROLLER
LiP
o B
A
T
T
ER
Y
CONTROLLER MODE SET-UP
TIPS:
#1:
When the
controller LED flashes
3 times quickly, the
trim is at middle of
trim range.
#2
: If you are
uncomfortable
trimming the drone in
flight, you can land
onto a flat surface and
make your trim
adjustments.
#3:
To reset trim
adjustments, hold the
and the buttons
down for 2 seconds.
R