01742
Front
B
A
A
B
POWERING UP AND PAIRING
Once lights turn solid, drone is ready to fly.
ONE TOUCH STUNTS
REPLACING DAMAGED BLADES
Turn on controller. (Before initial use, install
new batteries into controller. See reverse.)
Place the drone on level surface for
calibration.
Insert fully charged LiPo battery into
theunderside of the drone, then connect the
battery to back of the drone. (See next page.)
FLYING GUIDE
STUNT DRONE BUILDER
E1700
Forward/
Backward Trim
Left/Right Trim
FLIGHT CONTROLS
Fly Right
Fly Left
Rotate
Left
Rotate
Right
Up
Down
Fly Forward
Fly Backward
Power
Auto Mode
Indicator
Manual Mode
Indicator
Rotation Trim
1 2 3
LOW
MED
1 2 3
HIGH
1 2 3
FLIGHT SENSITIVITY SWITCH
It is best to start with
LOW
sensitivity
until you master flying.
LAUNCH/LAND BUTTON
PRESS TO LAND
PRESS TO LAUNCH
BASIC FLIGHT MANEUVERS
AUTO AND MANUAL FLIGHT MODES
NOTE
:
Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed.
CAUTION!
The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before
attempting stunt functions.
FLIP IN 4 DIRECTIONS
1 Bring the drone to a mid-air hover without flying in any
direction. Remove finger from the RIGHT thumb stick.
2 While hovering, tap and hold the STUNT button.
3 Then quickly tap the RIGHT thumb stick in the direction
you want the drone to flip.
BARREL ROLL LEFT OR RIGHT
While flying forward (or reverse), tap the STUNT button.
Stunt Button
AUTO
mode is best for new
pilots. Begin by pressing the
LAUNCH button for takeoff.
The drone will hold its altitude,
and gradually fly up or down
when you press up or down on
the left thumb stick.
MANUAL
mode is better for
experienced pilots. When the left
thumb stick is pushed all the way
up the drone will spin its motors
as fast as it can while maintaining
stability, and when the left thumb
stick is pushed all the way down
the motors will stop spinning
completely.
R
L
AUTO
MANUAL
FLIGHT MODE
LAUNCH
LAND
R
L
AUTO
MANUAL
FLIGHT MODE
LAUNCH
LAND
Flight Mode
• Reset controller to
factory settings:
Hold F Trim, B Trim,
and Power for
3 seconds.
LiP
o B
A
T
T
ER
Y
If for any reason you need to immediately stop
the drone, hold down the stunt button (for drones
that don't have a stunt button, use the video
button) and move both thumb sticks down and
away from the center of the controller.
LAUNCH
AUTO
MANUAL
FLYING MODE
R
L
L AUNCH
L AND
Press
LAUNCH
to automatically launch a few feet off the ground.
Move
LEFT (Throttle)
thumb stick up or down to make drone
fly higher or lower and left or right to rotate.
Use
RIGHT (Directional)
thumb stick to fly forward,
backward, left or right.
Press
LAND
to automatically land.
To make flying easier, place the drone on the ground in front of you
with the drone facing away from you (green blades forward). You
should be facing the same way the drone is facing.
R
L
AUTO
MANUAL
FLYING MODE
LAUNCH
LAND
R
R
L
LAUNCH
LAND
Alternatively you can use the left thumb stick to land the drone. Hold the left
thumb stick all the way down for about 2.5 seconds after the drone has
safely reached the ground, and the motors will stop spinning.
Use the included
screwdriver to unscrew
the propeller, then pull up
on propeller to detach.
Match A propellers to A
legs and B propellers to B
legs. Replace screws and
tighten. See image to right.
