SKY-HERO Little Spyder, Instruction Manual, Page: 7 / 30

7
TOOLS REQUIRED FOR ASSEMBLY
2 mm hex wrench •
2.5 mm hex wrench •
3 mm hex wrench •
7 mm wrench •
A reamer tool (optional) •
Double-sided adhesive tape •
Blue threadlock (Loctite) •
12 mm Heat Shrink tubing •
ADDITIONAL EQUIPMENT THAT YOU WILL NEED (to fly air-
craft)
Radio Transmitter (and compatible 6 channel or more receiver) •
Lipo Battery 3S ( • Capacity of 3000mAH or higher recommended)
PLANNING YOUR INSTALLATION
Before starting to assemble your
SKY-HERO
aircraft, it is important to plan your build. You
should check that you have all of the parts and components that you will need. You should also think
about what accessories you might want to add to the aircraft and also where on the frame you will
locate them. For example you might want to add a Camera Gimbal or navigation lights. You need
to consider how any accessories that you might add, could affect the Centre of Gravity as well as
things like which route the wiring will take. Some wires might need to be shortened whilst others mi -
ght need to be extended. One tip is (prior to starting the assembly) lay out your electronics, motors,
wiring, etc against the frame and check that there is space for everything.
If you will locate the ESCs in the arms of the Aircraft as recommended, it may be necessary to ad
-
just the length of their cables to avoid excessive cabling in the main body or the tubes of the frame.
Remember that if you will fold the arms away after flying, you may need some extra cable to allow
for the bending of the arms.
The setup of the NAZA flight controller is not covered within this manual as full instructions can be
found on the DJI website ( www.dji.com ) under NAZA-M ( http://www.dji.com/product/naza-m-v2) .
You should make sure you have access to the manual and necessary software, in order to configure
the flight controller and to carry out your pre-flight checks.