~ 8 ~
3. Programming
3.1 Programming Only One Call Address (One Call Button for One Intercom Unit)
Set the desired call address for the device on the DIP-Switch following the SKS-BUS Address Table in
the appendix. Each call address is assigned to one call button in the door station. The call address
distribution is stored in the door station or in the door speaker 4503, 4508 or 4808.
3.2
Programming up to 4 Call Addresses
(2...4 Call buttons for an Intercom Unit or Internal Call Units)
The intercom unit can store up to 4 SKS-BUS call addresses for house call, internal call or group call
addresses. The first address is the main address and is transmitted as the device identification. The
intercom unit will respond to up to 3 additional call addresses for incoming house calls (call button for
the door station), internal calls (talking between two intercom units) and group calls (talking between
one intercom unit and up to 4 other intercom units).
Note:
With intercom unit that can mute the ringer, the ringer must be turned on during programming.
Step
Description
1
Set the call address on the DIP-Switch. The 1st call address is the house call
(call button on the door station).
2
Push the programming button for about 5 seconds until you hear the control
tone.
3
After this control tone sounds you will hear a short tone that signals that the
first call address has been programmed. The number of short tones indicates
the memory location at which the call address was stored.
4
To program additional call addresses, repeat steps 1 to 3. A maximum of 4 call
addresses can be stored. If call addresses need to be changed, all call
addresses must first be deleted, as described under 3.3.
Note:
After programming is finished, set the DIP-Switch to the main address again so that it is possible
o to assign the button to the intercom in the case of a fault.
3.3 Delete All Call Addresses
Call addresses can not be deleted individually. All addresses are deleted every time. Hold the
programming button down for around 25 seconds. While you are doing this, you will hear several control
tones. Deletion is completed when you hear a 3-second-long high-pitched signal tone. Now release the
programming button. All call addresses have been deleted.
Note:
After you have deleted the programmed call addresses, only the address set on the DIP-Switch
is in effect, as described under 3.1.
For special function
only
DIP switch
programming key
