GENERAL FUNCTIONS AND CONTROLS (Cont.)
UDJ-1000 Instruction Manual Page
5
8. JOG WHEEL
a
The jog wheel will act as a frame search control when the track in the pause or cue mode, allowing
you to set a point.
b
The wheel also works as a pitch bend during playback. Turning the wheel clockwise will increase the
pitch percentage up to 100%, and turning the wheel counterclockwise will decrease the pitch
percentage down to -100%. The pitch bend will be determined on how long you turn the jog wheel
continuously.
c
The jog wheel can be used with the hold of the TIME and RATIO knob to set effects and samples
parameter adjustment.
There are several varied modes can be adjusted for Jog Wheel light ring.
1. To select light ring you desired; press PRESET button to enter internal menu, and turn FOLDER knob
to search “JOG MODE” menu.
2. Turn the TRACK knob to select the MODEs you want to adjust.
3. Press SHIFT button and turn TRACK knob to adjust the setting value.
1) MODE 1 - It will show the playing point indicator around the ring. You can adjust the setting
value range 1 of smallest indicator to 23 of full circle indicator.
2) MODE 2 - It will indicate the playing point opposite (on->off / off
on) when the Jog Wheel is
touched. You can adjust the setting value range 1 of smallest indicator off to 23 of full circle off.
3) MODE 3 - It will show the playing point indicator around the ring and flash to the playing level in
both sides. You can adjust the setting value range 1 of smallest playing point indicator to 23 of
full circle indicator.
4) MODE 4 - It will flash to the playing level around the ring.
5) MODE 5 - It will always on. You can adjust the setting brightness range 1 to 100.
6) MODE 6 - It will flash related to the setting speed. You can adjust the setting speed range 1 of
fast flash to 100 of slow flash.
7) MODE 7 - It will show the playing point similar to trail effect.
8) MODE 8 - It will light when the Jog Wheel is touched.
9. TAP BUTTON -
This button is used for manual BPM. When in manual BPM mode, tap this button to the beat of
the current track. Hold the TAP button for 1 sec. to activate Auto BPM.
10. PITCH BEND BUTTONS -
The desired pitch of music decrease or increase when button is pressing and
returns to the original pitch when the button is released.
11. SAMPLE BUTTON -
a
Press this button, then press the desired BANK button to set the sample loop mode (LED is on).
b
When sample mode is set, then sampler will mix the music together.
c
And press the SAMPLE button again to set the sample single mode (LED is flash).
d
Press the SAMPLE button again to cancel sample function.
12. BANK BUTTONS 1~4 -
These buttons are used to store either four cue points or four samples. Each Bank
Button can store either a sample or a cue point. To play your programmed samples, press the Sample button
and then press the Bank Program button.
