8
Operation
User Manual
SC112N-A
The electronic controller can be programmed to switch the fridge
automatically between Normal and Energy Saving modes, depending on
customer use. If the front door (electronic controller side) is not opened for
a set amount of time, the fridge will automatically enter Energy Saving
mode. To set the times for automatic switching between Normal and Energy
Saving mode, follow the procedure below.
To change the time between ‘Normal’ and ‘Energy Saving’ modes
Temperature
Setpoint
The fridge temperature setpoint is factory set at 2°C for storing perishable
products (all shelves maintain temperatures below 5°C). The cabinet
setpoint can be adjusted between 0°C and 4°C.
SKOPE does not recommend that the setpoint be changed unless it is
absolutely necessary, and then only by small increments at a time.
To view and adjust the temperature setpoint
1. Press and hold the
Set
button for 3 seconds until
PS
is
shown on the display, indicating entry into the controller
settings menu.
2. Press the
Down
button to scroll through the menu until
r6
is shown on the display.
The
r6
value is the time (in hours) without the door
being opened. When this time is reached (during store
closing hours or quiet periods) the electronic controller
will switch the fridge from Normal mode to Energy
Saving mode. The
r6
value must be ≥1 hour.
IMPORTANT
Do
not
set r6 to 0.
3. Press the
Set
button. The current
r6
value (in hours) is shown on the display.
4. Press the
Up
or
Down
button to increase or decease the value (in hourly
increments).
5. Press the
Set
button to temporarily save the new
r6
value.
6. Press the
Down
button to scroll the menu until
r7
is
shown on the display.
The
r7
value is the maximum time (in hours) that the
fridge will stay in Energy Saving mode. When this time
is reached the electronic controller will switch the fridge
from Energy Saving mode to Normal mode.
7. Press the
Set
button. The current
r7
value (in hours) is shown on the display.
8. Press the
Up
or
Down
button to increase or decease the value (in hourly
increments).
9. Press the
Set
button to temporarily save the new
r7
value.
10. Press and hold the
Set
button for 3 seconds to permanently save the new
values and exit the controller settings menu.
1. Press and hold the
Set
button for 3 seconds until
PS
is
shown on the display, indicating entry into the controller
settings menu.
Continued over the page
