6
Installation
User Manual
SKOPE B550/660-2 and BME550-2
Fitting the Kick Panel
For transit purposes the kick panel is packed inside the cabinet, with the
electronic controller temporarily attached to the front of the refrigeration unit.
Before fitting the kick panel to the cabinet the controller must be attached to
the inside of the kick panel.
To fit the kick panel
1. Loosen the two keyhole screws holding the controller box onto the
refrigeration unit. Lift the controller box off the keyhole screws and
carefully pull out from the unit compartment.
2. Locate the controller box onto the back of the kick panel, so the two
screws in the top of the controller box slot into the keyholes in the kick
panel. Tighten the keyhole fixing screws through the top set of slots (see
Figure 2 below).
3. Open the cabinet doors wide open (this is to allow fitting of the kick
panel). Sit the kick panel over the two corner bottom locating brackets
and push on to the two top keyhole fixing screws. Tighten both the
screws. Ensure the controller cables are well clear of any sharp objects
on the refrigeration unit.
Fitting the Illuminated Sign
For transit purposes the illuminated sign is packed inside the cabinet.
To fit the illuminated sign
1. Loosen the four retaining screws on top of cabinet, and fit both the sign
side panels over the screws. Slide the panels forward, flush with edges
of the cabinet, and tighten the screws.
2. Clip the sign rear panel into retaining slots on the rear of the sign sides
(see Figure 5 over page).
3. Fit sign unit by engaging clips into both retaining slots on the front of
each side panel, and pull sign unit firmly down. Ensure the two screws
in the back of the sign unit fit into slots in the cabinet top angle bracket,
and then tighten all the screws.
4. Turn the sign retaining clips, on top of each side panel, to hold sign unit
firmly in position (see Figure 4 over page).
5. Connect the sign ENSTO 3 pole plug into the roof top power supply
socket.
Figure 2:
Attaching the Electronic Controller
Figure 3:
Electronic Controller Relocated
Fixing Screws
Controller
Kick Panel
