
EN
18
Caution. During the drilling operations suck up the produced chips to
prevent them from falling in the safety belt winding mechanism, or to
avoid damaging the inside trunk lining panel.
Cut out the attached template (H).
Assembly procedure
Fastening points for fitting the trunk grille in the roof panel between the
C-pillar and the D-pillar of the vehicle.
- 3, 4, 5, 6, 7 -
- Position the template (H) for marking the hole into the roof panel
between the C-pillar
and the D-pillar of the vehicle carefully according to the description on the template itself.
- Mark the spots for future holes with an upholstery pin.
Advice. Using a pin, check the correctness of placing the template (the
position of the future hole). Proceed as follows: with an upholstery pin
punch several times the roof panel to make sure that under the
marked spot there is a hole in the roof sideplate of the vehicle.
- Remove the template and put it to a suitable place. Then use it to mark placement of the
hole on the the other side of the car.
-
By oscillatory movement of the pin engaged up in the hole of the roof sideplate check
correct position of the future hole.
- At the marked spot drill a hole of 26 mm diameter in the roof panel (use the drilling tool
MTX 9-193/B).
- Rivet the riveting nut (B)
in the hole in the roof sideplate under the roof panel using the
riveting tool MTX 9-193/A as follows:
- screw the riveting nut (B) on the riveting tool,
- insert the tool with the fitted riveting nut into the opening in the roof sideplate,
- by gradual tightening the nut on the tool rivet the riveting nut,
- keep tightening the nut on the tool until it stops, otherwise the riveting nut will be lose,
- release the nut and uncsrew the tool.
- Screw the spacer (C) on using the screw M8 x 50 and the self-locking nut M8 as follows:
- screw the spacer over flat washer to the nut on the screw M8,
- tigthen the nut to the spacer,
- insert the tool with the spacer into the hole in the riveted nut and screw the spacer in.
- release the nut and uncsrew the screw.
- Place and then press the cap (D) onto the protruding shank of the spacer
so that the
wider part of it was directed towards the window.
- When mounting the cap be careful not to deform the panel of the roof. If the roof panel
appears to be uneven at the cap, pull it out and straighten it using the upholstery pin.
In the same way then create the mounting point of the trunk grille in the roof
panel on the other side of the car.
Summary of Contents for 5E9 071 195
