Skoda 2015 Superb, Owner'S Manual

Page: 247 / 276

›
Carefully remove the connector from the lamp assembly in the direction of
the arrow
4
.
Fitting
›
Slide the plug in the opposite direction of the arrow
4
» Fig. 275 into the
light.
The locks on the plug must be inserted securely.
›
Insert the lamp with the holes
D
onto the studs
C
in the body.
›
Carefully press the light into the studs on the bodywork.
Ensure that the wiring harness does not become pinched between the body
and the lamp.
›
Screw the tail lamp into place and install the cover.
The cover must engage securely.
If you are not sure whether the wiring harness has become pinched, we rec-
ommend that you have the light connection checked by a specialist garage.
CAUTION
■
Ensure that the wiring harness does not become pinched between the body
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
■
Ensure that the vehicle paintwork and the tail lamp are not damaged when
removing and installing the lamp.
■
Make sure that when refitting the seal
C
» Fig. 276 on page 245 it is inser-
ted correctly. Water and dirt may get into the lamp if the cover is not replaced
properly - there is a risk of damage to the lamp!
Replacing bulbs in rear light
Fig. 276 Tail light / bulb replacement
Read and observe and on page 242 first.
›
Turn the holder with the bulb
A
or
B
» Fig. 276 in the direction of the arrow
1
.
›
Remove the socket with the bulb from the lamp housing in the direction of
arrow
2
.
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Reinsert the holder with the bulb into the lamp housing and turn in the op-
posite direction of the arrow
1
to the stop.

245
Fuses and light bulbs