Skoda 2015 Superb, Owner'S Manual

Page: 164 / 276

Note
■
During control, speed can be increased by pressing the accelerator pedal. Re-
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
■
By pressing the button
D
» Fig. 198 during the regulation this is cancelled
and the Speed Limiter is activated.
Speed Limiter

Introduction
This chapter contains information on the following subjects:
Operation
162
Operation description 163
The Speed Limiter limits the maximum driving speed to the set speed limit.
This limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter monitors a potential set speed limit
excess is referred to as
Regulation .
WARNING
The general information relating to the use of assistance systems must be
observed
» page 142, in section Introduction .
Operation
Fig. 199 MAXI DOT display (monochrome): Examples of Speed Limiter sta-
tus displays
Fig. 200 Segment display: Examples of Speed Limiter status displays
Read and observe on page 162 first.
Status display of the Speed Limiter » Fig. 199 , » Fig. 200
Speed limit is set, control is inactive (in the colour display the digits of
speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-
lighted).
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for start of control
The Speed Limiter is activated.
The current speed is higher than approx. 30 km/h.







162
Driving