INSTRUCTIONS FOR AUTO-FEED SET-UP:
STEP 1–
BASE STAND AND TELESCOPING BASE POLE ASSEMBLY
Fully extend the legs of the
Base Stand (A)
until they lock into place. Stand the base
on the ground. Attach
Telescoping Base Pole (B
) into the top of the
Base Stand (A)
by
lining up the push pin with the hole. Lock push pin into place.
STEP 2–
ATTACH THE SUPPORT CLAMP AND TUBES
Slide the
Support Clamp (C)
into the
Telescoping Base Pole (B)
and secure with the
knobs on the pole. Attach the
Feeder Tube (G)
and
Straight Tube (H)
together. Fit
flanged end of the Straight Tube over the Feeder Tube. The motor slot should be facing
the ground. Slide the tubes into the
Support Clamp (C)
and clamp.
Note:
Make sure that the straight tube is angled down, as pictured below.
STEP 3–
PLACE 3 AA BATTERIES INTO AUTO-FEED MOTOR
(Batteries not Included)
Unscrew the battery cover on the
Auto-Feed Motor (D)
with a Phillips-
head screwdriver. Install 3 AA
batteries into the motor and replace
cover. Slide
Auto-Feed Motor (D)
into
Motor Clamp (E)
(make sure to
slide the motor in all the way).
H
G
E
D
