2021-06-24
Page 35 of 38
CU-M001 User manual
CHAPTER 5: OPTIONS ON THE SYSTEM
The system has the following pay options.
Synchronisation
The Aux input can be used to stop/Mute the sensor. If just for a short time, the data quality is not
reduced, if for a longer time the on screen data will become invalid.
While the system is being muted an M symbol will show on the screen.
Mute is activated via Aux input or NMEA command when this mode is
activated.
1% accuracy
The signal analysis is changed and extra decimals are added to the outputs to give a better accuracy
and resolution. 1% accuracy requires careful calibration in very calm conditions, and may require all
5 calibration points.
activation of options
It is possible to activate some options by entering a code number in the “DL2 Setup” . In the bottom
left of the screen the screen, select options, and enter the code to enable the option you require.
The option will be activated, and can then be enabled or disabled by the user. These codes can be
optained from SKIPPER Electronics directly or via your distributer. To get this code you must supply
the serial number of the DL2 system (available on the JB70D2 setup menu) and a code unique to
your system will be sent in return (fees may apply). If the system is supplied with options activated,
the code number for this option will be labelled on the JB70 unit close to the serial number label
