Page 24 of 38
2021-06-24
CU-M001 User manual
Calibration Status
The first calibration page is the “Calibration status”.(Indicated in green in below picture)
The page is set up to have an overview of calibration of the promary (speed and mounting) and
secondary sensors (tilt and temperature) . The system has 5 default speed calibration points. Each
of these can be adjusted within the indicated speed zone. The graph on the left shows these points
as well as the current measured speed and GPS SOG if available. The table to the right indicates
the likely quality of this data. The vessel should always have at least one ‘Sea test’ calibration at a
high speed.
To adjust, or to look closer at any of these settings, The type of adjustment can be selected at the
bottom of the page.
Pressing ‘BACK’ will return the user to the previous menu or displays.
Calibration curves
Blue line: STW calibration curve
Green line: SOG Calibration curve
Status of:
Speed calibration
Installation angle of sensor
Sea test speed calibration
Tilt offset
Temperature offset
Select calibration type:
Installation angle of sensor
Speed calibration
Tilt offset
Temperature offset
