PRODUCT INFORMATION MANUAL
SECTION: 9E DUETTE
®
SKYLIFT POWERVIEW
®
SYSTEM
ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: R.BOKTOR
PAGE 13
Connect the Power Source
NOTE:
When power is connected to the motor, a green LED below the manual control button
will flash to indicate the shade is ready for operation.
■
Refer to the appropriate page based on your order.
■
For battery wands (787mm and wider shades), see below.
■
For a satellite battery pack (for shade less than 787mm), see “If You Have a Satellite
Battery Pack...” on page 14.
■
For an optional DC power supply, see “If You Have a DC Power Supply...” on page 13.
If You Have Battery Wands...
Install the Batteries into the Battery Wands
■
Squeeze the cap latch to release and remove the cap.
■
Install AA Lithium batteries according to the instructions
on on
the battery wand label.
■
Replace the cap.
■
Align the tab with the end of the wand.
■
Press the cap on until it latches.
Mount the Battery Wands into the Battery Wand Holder
■
Remove the bottom rail cover.
■
Align the battery wands with the sockets toward
the motor.
■
Push the battery wands straight down into the
battery wand holder in the bottom rail.
CAUTION:
Be sure the cable does not become
pinched by the battery wand holder during
installation. Damage or overheating of components could result.
Plug the Power Cable into the Battery Wand
■
Connect the power cable into the both sockets on the battery wands.
■
Make sure the cable is not wrapped around the shaft.
■
Reinstall the bottom rail cover.
Proceed to ““Test the Shade” on page 16.
Tab
Slot
Cap
Latch
Battery
Wand
Squeeze
Battery Wand
Holder
Battery Wand
Summary of Contents for 9E DUETTE SKYLIFT POWERVIEW SYSTEM
Page 2: ......
