17
Aligning the bevel indicator
(Fig. 4 – Fig. 6)
The bevel indicator has been factory adjusted.
It should be rechecked prior to use for best
operation.
Required tools:
Philips head screwdriver (not included)
Flathead screwdriver (not included)
Combination square (not included)
3 mm L wrench
1. Loosen and remove the ‘screw - locking
washer - flat washer’ set and the drop foot
from the scroll saw. (Fig. 4)
2. Loosen the table bevel lock knob and move
the table until it is approximately at a right
angle to the blade. (Fig. 5)
3. Use a combination square (not included) to
set the table exactly 90° to the blade. If there
is space between the square and blade,
adjust the table angle until the space is
closed. (Fig. 6)
4. Lock the table bevel lock knob under the
table to prevent movement.
5. Loosen the screw holding the bevel scale
pointer and position pointer to 0°. Tighten the
screw.
Fig. 4
Drop Foot
‘Screw - Locking Washer - Flat Washer' Set
Fig. 5
Table
Bevel Lock Knob
Table Stop Screw
Bevel Scale
Pointer & Screw
Fig. 6
Blade
Combination
Square
Table
