Skier's Choice Moomba Craz 2019, Owner'S Manual, Page: 70 / 111

© 2018 Skier’s Choice, Inc. 69
Your Moomba boat cover is made from the finest material and
webbing to ensure that your boat will be protected in the off
season. The cover has been designed to fit securely around each
boat. If your new cover does not seem to be snug, a shrinkage
allowance has been sized in.
Use the following procedure when covering the boat:
• Be sure that the cover fits snugly at the bow then unfold from front
to back.
• Be sure to install cover pole(s) and adjust to proper height. This will
keep water from gathering in the center, which can damage the
cover.
• Pull the draw cord equally from both sides and tie off to the lifting
eyes on the stern.
• Place hangtyte rope overtower ski pole and draw cover tight by
pulling the rope.
Folding Cover
When folding the cover for storage, be sure the cover is dry. Take care
not to scratch the finish against rough surfaces. Store in a dry location.
Cover Repair
If the cover becomes damaged, immediately patch and reseal the area.
Use a tent seam sealer to reseal any new stitches. Spray fabric guard on
scraped or worn surfaces. Tears should be repaired professionally and
stitches sealed to prevent leakage.
Section 10
Service & Maintenence