Ski-Doo SKANDIC EXPEDITION 600 H.O. SDI 2005, Operator'S Manual, Page: 42 / 64

Increase the position would give the best acceleration. Fuel econo-
my would be reduced.
Adjustment
Just loosen locking nut enough to pull calibration screw partially out
and adjust to desired position. Do not completely remove the locking
nut. Torque locking nuts to 10 N•m (89 lbf•
in
).
CAUTION: Do not completely remove calibration screw other-
wise inside washer will fall off. Always adjust all 3 calibration
screws and make sure they are all set at the same number.
A16D0HA
1
TYPICAL
1. Loosen just enough to permit rotating of calibrate screw

WARNING
NEVER disassemble or modify the drive pulley.
Improper assembly or modifications could cause the pulley
to explode violently under the stress generated by the high
rotational speed. This could lead to serious injury including
the possibility of death.
See your SKI-DOO dealer to maintain or service the drive
pulley. Improper servicing or maintenance may affect per-
formance and reduce belt life. Always respect maintenance
schedules.
42
_________________________