7
STARTING PROCEDURE
• Re-check throttle control lever operation.
• Ensure that the emergency cut-out switch is in the ON position.
• Ensure the tether cut-out cap is in position and that the cord is
attached to your clothing.
• If applicable use the octane level switch to select proper octane
number according to fuel used.
• To prime, activate button until a pumping resistance is felt. From
this point, pump 2 or 3 times to inject fuel in intake manifold. After
priming, ensure that primer button is pushed back.
NOTE:
In very cold temperature, it is recommended to rotate primer
button 3-4 turns prior to pull it. This will eliminate the possibility of
sticking.
NOTE:
Priming is not necessary when engine is warm.
MMO2002_005_A.fm Page 7 Wednesday, June 27, 2001 2:36 PM
Summary of Contents for MX Z X 440 2002
Page 1: ......