Section 04
ENGINE
Subsection 08
(CARBURETOR)
04-08-4
MMR2000_123_04_08A.FM
Slide out carburetor and activate carburetor throt-
tle lever so that groove aligns with governor rod,
as shown in the next photo.
SLIDE OUT CARBURETOR AND ALIGN GROOVE
1. Carburetor throttle lever groove aligned with governor rod
2. Governor rod
3. Throttle return spring
Detach governor rod with throttle return spring.
Detach governor spring.
Remove carburetor.
NOTE:
Carburetor can be removed without re-
moving engine from vehicle, in that case remove
left side stud.
CLEANING AND INSPECTION
The entire carburetor should be cleaned with a
general solvent and dried with compressed air be-
fore disassembly.
CAUTION:
Heavy duty carburetor cleaner may
be harmful to the float material and to the rub-
ber parts, O-rings, etc. Therefore, it is recom-
mended to remove those parts prior to clean-
ing.
Carburetor body and jets should be cleaned in a
carburetor cleaner following manufacturer’s in-
structions.
Check for fuel soaked into float
no. 8
. Replace as
necessary.
Check float
no. 9
and float pin
no. 10
for cracks or
other damages affecting free movement. Replace
as necessary.
DISASSEMBLY AND ASSEMBLY
11,12, Main Jet and Nozzle
Place carburetor on a clean surface, then unscrew
main jet
no. 11
using a flat screwdriver, as shown
in the next photo.
1. Unscrew main jet using a flat screwdriver
A31C0SA
1
2
3
WARNING
Solvent with a low flash point such as gaso-
line, naphtha, benzol, etc., should not be used
as they are flammable and explosive.
A31C0TA
1
Summary of Contents for Mini Z 2000
