23
Starting the Engine
IMPORTANT:
On 2-TEC models if the low battery voltage pilot lamp
is on, battery would not have enough power to start the engine. In
this case, use the manual rewind starter.
IMPORTANT:
On 2-TEC and 4-TEC models if the battery is dead,
engine cannot be started. Have the battery recharged or replaced.
• Re-check throttle control lever operation.
• Ensure that the engine cut-out switch is in the ON position.
• Ensure the tether cord cut-out cap is set in place and that the cord
is attached to your clothing.
• Press START button.
NOTE:
You will not feel any button movement when you press it.
• Release START button when engine has started.
CAUTION:
Do not depress START button for more than 10 sec-
onds. A rest period should be observed between the cranking
cycles to let starter cool down.
If engine does not start on first try, wait few seconds before depress-
ing START button again.
NOTE:
2-TEC engine may be manually started with rewind starter if nec-
essary. There is no rewind starter on 4-TEC engine.
Emergency Starting
2-TEC Models
Only 2-TEC models are equipped with an emergency starting device.
Refer to
2003 ZX Series Operator’s Guide
(P/N 484 100 081).
WARNING
Do not apply throttle while starting.
Mmo2003-011a.book Page 23 Wednesday, January 29, 2003 3:52 PM
Summary of Contents for Legend SE 800 SDI 2003
