SKF TIH 100m, Instructions For Use Manual

Page: 15 / 116

13 SKF TIH 220m
E
nglish
7. Troubleshooting
A system fault will be indicated by an acoustic signal and one of the following fault codes on
the remote control display:
Display Fault Action
E03 E Overheated coil Wait until the induction coil cools.
Switch the heater OFF and then
back ON
E05 E Temperature increase of less
than 1°C (1.8°F) every 15
seconds (or every 30 seconds)
Check the temperature probe
connection. If the connection is OK,
select the 30 second interval as
described in section 6 or operate
the heater in TIME MODE
E06 E Temperature probe not
connected (or defective) or
excessive temperature drop
Check the temperature probe
E10 E Electronics communication
problem
Switch the heater OFF and then
back ON. If problem remains return
the TIH to SKF for repair
E11 E Electronics communication
problem
Switch the heater OFF and then
back ON. If problem remains return
the TIH to SKF for repair
E12E Electronics communication
problem
Switch the heater OFF and then
back ON. If problem remains return
the TIH to SKF for repair
8. Spare parts
TIH 220-PMV Power print 400 - 460V, 50 - 60 Hz
TIH 220-PLV Power print 200 - 240V, 50 - 60 Hz
TIH 220-Y10 Yoke 70 x 70 x 430 mm
TIH 220-Y6 Yoke 40 x 40 x 430 mm
TIH 220-YS Support yoke set - 70 x 70 x 150 mm (2x)
TIH CP Control print
TIH RC Remote control
TIH CB25A Circuit breaker 25A for TIH 220m/MV
TIH CB50A Circuit breaker 50A for TIH 220m/LV
TIH P20 Temperature probe K type incl. cable and plug
LGAF 3E/0.035 Tube of anti-fretting paste for heater maintenance