13
and that no limbs can be caught in between if there are inadvertent movements.
•
Assemble the product only outside of the operating range of moving parts, at an adequate distance
from sources of heat or cold. Be careful not to damage other units in the machine or vehicle or impair
their function during installation.
•
Dry or cover wet, slippery surfaces accordingly.
•
Cover hot or cold surfaces accordingly.
•
Work on electrical components must be carried out by electrical specialists only. Observe any waiting
periods for discharging, if necessary. Carry out work on electrical components using voltage insulated
tools only.
•
Make electrical connections only according to the information in the valid wiring diagram and taking
the relevant regulations and the local connection conditions into account.
•
Do not touch cables or electrical components with wet or damp hands.
•
Do not bypass any fuses. Replace fuses with same type and rating only.
•
Do not drill holes to critical, load-bearing parts. Use existing boreholes whenever possible. Be careful
not to damage lines and cables when drilling.
•
Observe possible abrasion points. Protect the parts accordingly.
•
All components used must be suitable for use in:
–
the system’s maximum operating pressure, and
–
the system’s minimum and maximum ambient temperature range.
•
No parts of the centralised lubrication system may be subjected to torsion, shear or bending.
•
Before using any parts, check them for contamination, clean if necessary.
•
Before installation, prime the hoses between the doser group and the lubrication point with lubricant.
This makes it easier to bleed the system of air afterwards.
•
Observe the specified tightening torques. Use a calibrated torque wrench.
•
When working with heavy parts, use suitable lifting tools.
•
Avoid mixing up or wrong assembly of dismantled parts. Mark these parts accordingly.
5.10 Commissioning and daily start-up
Ensure that:
•
All safety devices are complete and work properly.
•
All connections are correctly connected.
•
All parts have been correctly installed.
•
All warning labels on the machine are complete, highly visible and undamaged.
•
Replace illegible or missing warning labels without delay.
5.11 Cleaning
•
There is a risk of fire and explosion when using flammable cleaning agents. Use only non-flammable
cleaning agents suitable for the purpose.
•
Do not use aggressive cleaning agents.
•
Do not use steam jet or high pressure cleaners. Electrical components may be damaged. Observe the
IP protection class.
•
Cleaning work on energised components may be carried out by electrical specialists only.
•
Mark damp areas accordingly.
