Technical Instructions
Linear drive Ecomag
Magnetic – The Linear Drives Company™
page 5/10
Connecting / disconnecting the actuator cable on the control unit
Connect the actuator cable in the direction of the arrow (see Fig. 7).
Note:
Observe the plug number.
Disconnect the actuator cable in the direction of the arrow (see Fig. 8).
Fig. 7 – Connecting the cable
Fig. 8 – Disconnecting the cable
Connecting / disconnecting the control device
Connect the control device plug (e.g. handswitch) in the direction of the arrow
(Fig. 9).
Note:
Observe the plug type.
Disconnect the plug in the direction of the arrow (see Fig. 10).
Fig. 9 – Connecting the cable
Fig. 10 – Disconnecting the cable
Closing the control box cover
Move the control box cover in the direc-
tion of the arrow (see Fig. 11).
The control box cover is only closed once
an audible click of the locking mechanism
is heard.
Fig. 11 – Closing the control box cover
1
2
1
2
You should ensure that the handswitch cable
plug is inserted correctly.
If the front film is damaged (i.e. allowing liq-
uid to penetrate), the handswitch must be
replaced. The handswitch would be damaged
if liquid were allowed to penetrate it!
Motor connections that are not occupied on
the control unit are sealed at the factory. The
seals must not be removed.
If liquid is allowed to penetrate the seals, the
control unit will be damaged!
Protection class IPX4 is only guaranteed if the
control box cover is closed with an audible
click of the locking mechanism, and the seal
edges and nose are not damaged.
L5311,2400E.1/12.03
