SKF AWAIV-12, User Manual

Page: 96 / 250

Performing an example test
The following chapter walks you through an example setup just as an operator would if a
motor was to be tested for the first time.
• The first thing to do is create a Motor ID that uniquely identifies the motor. This
example uses a 460V Delco motor.
• Next, a Test ID must be created for this motor and assigned to the Motor ID.
• Then tests will be run and the results reviewed.
• Finally, reports will be printed.
The motor for this example is a Delco 460V, three phase, wye wound, induction motor and
has the following data on the nameplate:
Model: 2G2104
Frame: 213
SN B-95
Insulation: B
Amb oC: 65degC
V: 460V
A: 4.2A
HP:
3
RPM: 1765
Hz: 60
LR Code: J
SF: 1.0
Des:
B
NEMA nom eff: 84
Duty Cycle: Cont
Using this information, we will fill out the Motor ID Nameplate form.
82 SKF Static Motor Analyzer—Baker AWA-IV User Manual
Test procedures